Graflex.org

[Tim Povlick]

I've acquired a 2-cell Graflex Flash (aka. light saber) and had a couple questions. (I've looked in the usual spots for a manual but none found. A check of this site didn't have the answers either.)

Dating: Bottom is stamped Graflex and has the patent number so from other posts this is sometime in mid-1940's?

Connections:
There are three round holes with bi-pin. One of these has a red push botton switch which fires the flash. I assume one of the bi-pins is for shutter, but which of the two remaining?

A "household" connection is in front and has 3.0 V-DC so I assume this is for remote power out of in?

Obtaining the round bi-pin connector seems a bit of a challenge. Paramount cords do not list this as an option, from what I can surmise. There is a bi-pin in rectangle however. Is this the correct one?

A slide switch lights a bulb which throws a nice tight beam out. Is this for aiming in the dark. People that have this in their face while taking flash snapshot find it most annoying.

The connection to camera looks like it needs a rail about 1/2" wide to attach to. Attachment to a Crown or Super seems to be missing something.

I can easily imagine developing a small black anodized aluminum bracket that fits neatly between the two existing flash brackets on a Super. This would be attached with button head bolts through holes drilled in the side of the camera. I however, hate the though of modifying one of these beauties even if the results look "factory". Opinions?

Stupid question but... I'd like to verify a D-cell sized BC flash and a dummy D cell can be used this in place of two alkaline batteries, foregoing the aforementioned aiming light, correct?

I am curious why the BC units for these flash bulbs are desired? So far I haven't had a bulb misfire. It seems modern alkaline batteries are very good match for the flash bulbs.

Since the B-C units are no longer available why not replace two or three D cells with a rechargeable Lithium battery that is around 4 volts, yielding 8 to 12 V at the bulb?


Thanks,

Tim

[45PSS]

http://www.paramountcords.com/graflex.asp
scroll to bottom of the page - Graflex flash plug - order by phone.

[Tim Povlick]

Thanks for the link on the connector and the ti about the mounting piece. I will order a flash cord.

Best Regards,

Tim