| View previous topic :: View next topic |
| Author |
Message |
Kim
Joined: 10 May 2001
Posts: 44
Location: upstate NY
|
 Posted: Thu May 10, 2001 6:10 pm Post subject: |
 |
|
The spring back on my anniversary speed graphic is too tight to allow for a 405 holder. It looks like there is enough tension in the spring to put a spacer and longer screws on the spring mounts to allow for the 405 back...but I am wondering if there is a standard approach to adapting for this back.
Thanks
Kim Hartshorn |
|
| Back to top |
|
 |
Les
Joined: 09 May 2001
Posts: 2682
Location: Detroit, MI
|
| Posted: Fri May 11, 2001 12:00 am Post subject: |
|
|
I don't know of a standard way to adapt a 405, but you idea sounds logical. Just be careful where you are puttin the spacers so you don't inadvertainly move the ground glass out of position.
_________________
"In order to invent, you need a good imagination and a lot of junk" Thomas Edison |
|
| Back to top |
|
|
Kim
Joined: 10 May 2001
Posts: 44
Location: upstate NY
|
| Posted: Thu May 31, 2001 11:35 pm Post subject: |
|
|
to follow up...i went to the hardware store and bought two longer screws and an aluminum spacer of about 1/4 and it works great and looks good...
have not tested the tension on a regular film holder yet but it holds the 545 and the 405 backs fine and it seems to hold a regular film holder tight also.
Kim |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
